CAD Help!

[asim5901]

Hi all,

Looking for any feedback on the following CAD design. It was meant to based upon the below design with a subtle crown instead of the secret halo but I feel the crown is too chunky? Any thoughts or other feedback very welcome!



https://www.brilliantearth.com/en-a...nd-Ring-Gold-BE1D2460-17969336/?did=&is_tab=1

 

[tyty333]

Your CAD does not look like the link you provided. They have included a yellow gold cup (with diamonds) that they are then inserting
the platinum head into. Not what your link is showing.

My opinion (feel free to ignore), hidden halos can be problematic. You will need the wedding band to sit under the
hidden halo so that the diamonds in the halo dont eat away at the wedding band. What type of wedding band do
you plan on getting?

 

[asim5901]

I agree - it was meant to be similar to the original design except for the halo to slightly resemble a crown but the execution looks slightly too bulky. I think part of the issue is the two ends of the shank don't taper upwards and inwards sufficiently like they do in the inspiration - I think a low profile band should fit under the halo if there is more of a taper?

 

[tyty333]

Ah, I missed the subtle crown....I think it looks like what you asked for. I see no taper on the linked setting.