need help vetting a diamond and its ASET scope image

[uclu]

Hi

I am looking at this diamond

1.21 ct, F, SI1, GIA3X, VSB Fluor, HCA 1.5

The vendor provided me with a picture and its ASET scope image, but doesn't have the idealscope image.



Can the experts here help take a look at the images and let me know if the diamond is alright?

Are there anything else that I should check for? I have asked about cloudiness from the very strong fluor, waiting to hear back.

It's priced at about $7500.
http://www.gia.edu/cs/Satellite?rep...ename=GIA/Dispatcher&c=Page&cid=1355954554547

These are the stats:
Length:6.77
Width:6.81
Depth:4.23
Total Depth:62.3%
Table percent:57
Crown height:15.5
Girdle (from):Medium
Girdle (to):Slightly thick
Polish:Excellent / Very Good
Symmetry:Excellent / Very Good
Crown angle:35.5
Pavilion depth:40.6


Using the AGA/NAJA cut class tool:
Tab Percent: 1A
Crown Angle: 2A
Crown Height: 1A
Pavilion Depth: 3B
Girdle: 1A
Depth: 1A
Polish: 1A
Symmetry: 1A
TotalGrade: 3A

Thanks a lot!

 

[Lorelei]

Hi uclu,

This is a very well cut diamond, it's not cut to Superideal standards but it is definitely cut to a very high level and could be a beautiful diamond, it depends what you are looking for. That you have checked the VSB isn't an issue will be a deciding factor, but you have that in hand. Also ensure it is eye clean to your standards also by checking with the vendor, if the above get a favourable report, then it is definitely worth serious consideration for purchase.

 

[uclu]

Thanks Lorelei!

Out of interest, does an ASET scope image supercede an ideal scope image? Like if the ASET scope checks out, it's a guarantee of performance and other cut grades are no longer relevant?

Also, the ASET scope for this particular stone is alright right? I see mostly red with some blue and green at the usual place, and minimal white. Does the distribution of exactly where these colours are matter?

 

[uclu]

Bump, can anyone help regarding the ASET scope? Thanks!