Just listed this setting on LT.
Here is a link to the listing:
http://loupetroop.com/listings/sett...s-stamped-platinum-size-7-dot-25-setting-only
Vatche U-113 (but is stamped) Platinum Size 7.25 Setting Only. Stone is not included. In the interest of keeping everything about this setting transparent. I purchased this setting used and in very good condition. It had 6.9mm stone in it and after some hunting I found 6.9mm Amora Gem Ultra. I took the setting and stone to my local jeweler to be set and sized and they proceeded to mangle it. The ring then got sent back to Vatche (via Wink) who replaced the head and cleaned it back up again. It still has the faint lines from the up size to 7.25 but I am sure that it could be sized back down to its original size of 5.75 or a little smaller, which would remove these lines. As you can see Vatche did an AMAZING job fixing this setting, but unfortunately I was hoping to get the stone set lower then they could get it. The new head with the stone sits at 7.5mm off the finger and I cannot do anything more than 6.5mm. I LOVE LOVE LOVE this stone and would really like to keep it versus selling the entire ring. I have both for sale, but if someone is willing to take the chance setting another stone into this setting, here you go. I am asking $1100 and this includes USPS Priority Shipping with Insurance.
Here is a link to the listing:
http://loupetroop.com/listings/sett...s-stamped-platinum-size-7-dot-25-setting-only
Vatche U-113 (but is stamped) Platinum Size 7.25 Setting Only. Stone is not included. In the interest of keeping everything about this setting transparent. I purchased this setting used and in very good condition. It had 6.9mm stone in it and after some hunting I found 6.9mm Amora Gem Ultra. I took the setting and stone to my local jeweler to be set and sized and they proceeded to mangle it. The ring then got sent back to Vatche (via Wink) who replaced the head and cleaned it back up again. It still has the faint lines from the up size to 7.25 but I am sure that it could be sized back down to its original size of 5.75 or a little smaller, which would remove these lines. As you can see Vatche did an AMAZING job fixing this setting, but unfortunately I was hoping to get the stone set lower then they could get it. The new head with the stone sits at 7.5mm off the finger and I cannot do anything more than 6.5mm. I LOVE LOVE LOVE this stone and would really like to keep it versus selling the entire ring. I have both for sale, but if someone is willing to take the chance setting another stone into this setting, here you go. I am asking $1100 and this includes USPS Priority Shipping with Insurance.
300x240.png)