Hello Pricescope,
I have been reading the forums and searching the internet for quite some time, and think that I am finally at the point where I am knowledgeable enough to buy. I have been looking for round brilliant stones in the 1.5 - 1.8 carat range with excellent cut (plus or minus on the hearts and arrows), H-G color, and eyeclean (VS1 - SI). Needless to say the price of a stone in this range can be quite pricy, anywhere from $15,000 - $21,000 with AGS or GIA certificates. Frankly, that is more that is more than I wanted to pay. Ideally, was not trying to pay above $15000 for both a diamond of this quality along with a platinum setting with small sidestones. One way that I have found to keep the cost down was to look at primarily EGL certified stones. I know there reputation both on this forum and in general has not always been associated with a great deal of enthusiasm, but I figure if the stones truly grade out as what the certificate indicates this can be a way to save several thousand dollars.
So...let''s begin. Of coure I have a friend.... everyone always has one. His family member is a jewler in the diamond district in LA. He uses primarily EGL graded stones. He agreed to help me find a nice diamond in the above price range and with the above specs.
In any case I traveled from the east coast to LA to go look at some stones, hoping to find a great deal. Well, when I arrived he sat me down with about 6 stones all EGL certified. In general they were all between 1.5 - 1.75 carat color was about H and clarity ranged (via certificate from vs1 - vs2), all were Ideal or Ideal plus cuts. Some were true hearts and arrows as indicated by the certificate.
Well at the time I decided on the following stone:
1.75 carat round brilliant
7.84 - 7.80 x 4.70 mm
cut: EGL ideal plus (true hearts and arrows indicated on cert and I viewed it with an Idealscope)
Clarity: VS2
Color: H
Crown: 34.0
Pavilion: 40.7
Table percent: 58%
Girdle: 1.4% - 2.2%
Depth: 42.6%
pavillion height: 14.3%
crown height: 42.6%
polish: very good
symmetry: very good
cutlet: none
Fluorescence: none
HCA score 0.8
Price: $10,800
Well, looking at the stone, it did shine. However, it appeared significantly more yellow than an H (maybe a K). Also, I could see small mineral inclusion under the table and within the pavilion with the naked eye. But in the end because of the price, I decided to go with this stone. The jeweler also made me a very nice platinum setting with .40 carat side stones G-H in color with vs clarity (size 6 ring) for $1000.
Now when I finally received the stone, of course I took it to a number of independent jewlers to see what they thought. Needless to say I was somewhat surprised and disturbed with their comments. First of all, there first reaction was "it is very yellow". No one thought it was an H, maybe a K. One reputable jewler did pull out a set of master stones and when viewed with the table down, we actually did finally agree that it could be a low H. For some reason based upon the cut, it appeared significantly more yellow when viewed from the top down and from the side. With regard to clarity, definitely not a VS2. It may have been and SI2 or even an I1. While the inclusions were small and would really affect a quick inspection, they were definitely present and should have not been there based on the certificate. Everyone did agree that it was an excellent cut, although shallow, and based upon dimension was in fact the diamond I purchased.
In the end, being very disappointed, I decided to return the stone.
I pretty much refused to by a stone sight unseen. So I returned to LA, to try this again. Well, second time around, I pretty much realized to truly get a stone I was happy with, I was going to have to unfortunately spend more money.
This time around, I looked at about 8 more stones that he personally picked out for me. All were between 1.7 - 2 carats and definitely more expensive. After looking through these stones very carefully with a loupe and an ideal scope, I decided on the following stone.
1.81 carat round brilliant
7.88 - 7.82 x 4.81 mm
cut: EGL ideal plus (non-hearts and arrows; arrows were present but a true hearts pattern was not)
Clarity: VS1
Color: G
Crown: 36.0
Pavilion: 41.1
Table percent: 57%
Girdle: 0.8% - 1.7%
Depth: 61.30%
pavilion height: 15.80%
crown height: 43.20%
polish: very good
symmetry: very good
cutlet: very small
Fluorescence: faint blue
HCA score 5.3
Price: $13,800
The following stone looked amazing! As far as I could tell, everything with the certificate was spot on. And despite being a non-hearts and arrows cut, this particular stone looked as good, if not better, than other hearts and arrows diamonds that I have viewed EGL, AGS or GIA. I was surprised that the HCA score was so high at 5.3. Perhaps it was the cutlet #. I am not sure what an appropriate value for this stone should be, as it only says very small on the certificate.
This time around I decided to have it independently appraised by a GIA GG gemologist. I was much happier this time around. Essentially everything was spot on with the exception of the clarity. Unfortunately, there was a very small nick in the girdle that lowered the clarity from VS1 to VS2. However, the gemologist did note that the nick could be polished out with a total loss of carat weight of .01 to 0.02 or re-cut to entirely remove the nick with a total carat loss of .05 - .06.
I was wondering if I could obtain some advice as to whether or not this would be a good stone to purchase despite the nick? Is it still a good value at that price with a VS2 clarity rating. Also, can anyone advise me as to why the HCA score is so high?
Thanks
