CAD check!

[yankees1997]

Looking for any opinions on this cad! It’s an engagement ring. Stone is 2.56 emerald cut, d color, vvs2.

I am adjusting the band width and thickness, is the diamond set too high?

 

[Dreamer_D]

How are you planning to adjust the bandwidth and thickness?

The stance of the ring is at the higher end. The only way to change it would be to change the way the stem is connected to the shank, so it will alter the aesthetic. It’s up to you.

 

[yankees1997]

How are you planning to adjust the bandwidth and thickness?

The stance of the ring is at the higher end. The only way to change it would be to change the way the stem is connected to the shank, so it will alter the aesthetic. It’s up to you.

Increasing the width and thickness so it has more durability.

I was concerned about the stone possibly catching on something worst case scenario